VUE AWD V6-3.5L VIN 4 (2004)
10. Remove the steering gear to cradle mounting bolts.
11. Remove the steering gear through the right side of the vehicle.
12. With heat shield equipped steering gears, remove the heat shield. Save for installation.
Installation Procedure
1. If applicable, install the heat shield.
Important: Ensure the stabilizer is swung in the upmost position for gear clearance.
2. Install the steering gear from the right side of the vehicle.
3. Center the gear mounting bushings into the cradle supports.
Notice: Refer to Fastener Notice in Cautions and Notices.
4. Hand start both steering gear to cradle mounting bolts.
^
Tighten the bolts to 110 Nm (81 ft. lbs.).
