VUE AWD V6-3.5L VIN 4 (2004)
^
Position the cam nut in same position as in the upper control arm.
2. Install the toe link to support nut and bolt.
Notice: Refer to Fastener Notice in Cautions and Notices.
3. Install the toe link to the knuckle,
^
Tighten the nut and bolt to 160 Nm (118 ft. lbs.).
IMPORTANT: There are two different toe links and toe link bolts used on this vehicle. You must identify which is on the vehicle and use the
corresponding torque value.
4. Tighten the toe link to support bolt.
^
Tighten the bolt
If the bolt is black with a 15 mm head, tighten the bolt to 145 Nm (107 ft. lbs.)
If the bolt is silver with a 21 mm head, tighten the bolt to 160 Nm (118 ft. lbs.)
5. Lower the vehicle.
6. Check the rear alignment.
