VUE AWD V6-3.5L VIN 4 (2004)
Shift Cable: Service and Repair
Automatic Transmission Range Selector Cable Lever Replacement
-
Tools Required
-
J 36346 Fascia Retainer Remover
Removal Procedure
Notice: The control cable must be disconnected from the transaxle range switch lever prior to disconnecting it from the control cable bracket.
Otherwise damage to the manual shift shaft may result, requiring transaxle disassembly.
1. Raise and support the vehicle.
2. Remove the tire and wheel.
3. Remove the left splash shield.
4. Remove the range selective lever bolt and cover.
5. Using the J 36346, disconnect the control cable from the transaxle range switch lever.
6. Remove the transaxle range switch lever nut (4), lock nut (3), washer (2), and lever (1).
Installation Procedure
Notice: Refer to Fastener Notice in Cautions and Notices.
1. Install the transaxle range switch lever (1), washer (2) lock washer (3), and lever nut (4).
-
Tighten the transaxle range switch lever nut to 16 Nm (12 ft. lbs.).
2. Snap the cable end fitting onto the ball stud of the transaxle range switch lever. An audible snap will be heard when properly installed.
3. Install the battery tray and bracket.
4. Install the battery.
5. Install the range selective lever bolt and cover.
-
Tighten the bolt to 10 Nm (89 inch lbs.).
6. Install the left splash shield.