VUE AWD V6-3.5L VIN 4 (2004)
Transmission Speed Sensor: Service and Repair
Input Speed Sensor Replacement
Input Speed Sensor Replacement
Removal Procedure
1. Raise and support the vehicle.
2. Disconnect the wiring harness from the input speed sensor.
Important: Do not damage the input speed sensor or transaxle case.
3. Remove the input speed sensor bolt/screw.
4. Remove the input speed sensor, and the input speed sensor O-ring.
Installation Procedure
1. Apply automatic transmission fluid to the new input speed sensor O-ring seal.
2. Install the new input speed sensor O-ring seal onto the input speed sensor.
3. Install the input speed sensor into the transmission case assembly.
Notice: Refer to Fastener Notice in Cautions and Notices.
4. Install the input speed sensor bolt.
-
Tighten the input speed sensor bolt 12 Nm (87 inch lbs.).
5. Connect the wiring harness to the input speed sensor.
6. Lower the vehicle.