VUE AWD V6-3.5L VIN 4 (2004)
Fluid Pressure Sensor/Switch: Service and Repair
3RD Clutch Pressure Switch Replacement
3rd Clutch Pressure Switch Replacement
Removal Procedure
1. Raise the vehicle.
2. Drain the transmission fluid.
3. Disconnect the wiring harness from the 3rd clutch pressure switch.
4. Remove the 3rd clutch pressure switch and washer.
Installation Procedure
Notice: Refer to Fastener Notice in Cautions and Notices.
1. Install the 3rd clutch pressure switch and washer.
-
Tighten the input speed sensor bolt 20 Nm (14 ft. lbs.).
2. Connect the wiring harness to the 3rd clutch pressure switch.
3. Fill the transmission with transmission fluid.
4. Lower the vehicle.