VUE FWD L4-2.4L (2008)
4. Assemble the two halves of the blower case assembly.
Notice: Refer to Fastener Notice .
5. Install the blower case assembly screws.
Tighten the screw to 1.5 N.m (13 lb in).
6. Install the HVAC module front of dash seal.
7. Install new seal washers to the evaporator pipes. Refer to Sealing Washer Replacement (See: Coupler HVAC/A/C Coupler O-ring/Service and
Repair/Sealing Washer Replacement) .
8. Instal the TXV and the backing plate to the evaporator pipes.
9. Install the TXV screws to the backing plate.
Tighten the screws to 3.5 N.m (31 lb in).