VUE FWD L4-2.4L (2008)
Malfunction Indicator Lamp: Testing and Inspection
Malfunction Indicator Lamp (MIL) Diagnosis
Diagnostic Instructions
*
Perform theDiagnostic System Check - Vehicle (See: Testing and Inspection/Initial Inspection and Diagnostic Overview/Diagnostic System
Check - Vehicle) prior to using this diagnostic procedure.
*
ReviewStrategy Based Diagnosis (See: Testing and Inspection/Initial Inspection and Diagnostic Overview/Strategy Based Diagnosis) for an
overview of the diagnostic approach.
*
Diagnostic Procedure Instructions (See: Testing and Inspection/Initial Inspection and Diagnostic Overview/Diagnostic Procedure Instructions)
provides an overview of each diagnostic category.
Circuit/System Description
Ignition voltage is supplied to the malfunction indicator lamp (MIL). The engine control module (ECM) turns the MIL ON by grounding the MIL control
circuit.
Reference Information
Schematic Reference
*
Instrument Cluster Schematics (See: Diagrams/Electrical Diagrams/Instrument Panel, Gauges and Warning Indicators/System Diagram/Instrument
Cluster Diagrams)
*
Engine Controls Schematics (See: Diagrams/Electrical Diagrams/Powertrain Management/System Diagram/Engine Controls Diagram Index)
Connector End View Reference
Component Connector End Views (See: Diagrams/Connector Views)
Electrical Information Reference
*
Circuit Testing (See: Testing and Inspection/Component Tests and General Diagnostics)
*
Connector Repairs (See: Testing and Inspection/Component Tests and General Diagnostics)
*
Testing for Intermittent Conditions and Poor Connections (See: Testing and Inspection/Component Tests and General Diagnostics)
*
Wiring Repairs (See: Testing and Inspection/Component Tests and General Diagnostics)
Scan Tool Reference
Control Module References (See: Testing and Inspection/Programming and Relearning) for scan tool information
Circuit/System Verification
Ignition ON, the MIL should turn ON and OFF when commanded with a scan tool.
Circuit/System Testing
1. Ignition ON, verify that the instrument panel cluster (IPC) warning indicators are illuminated.
‹› If the IPC warning indicators are not illuminated, test the ignition circuit for a short to ground or an open/high resistance. If the circuit tests
normal and the ignition circuit fuse is open, replace the IPC.
2. Ignition OFF, disconnect connector X1 at the ECM.
3. Ignition ON, verify that the MIL is not illuminated.
‹› If the MIL is illuminated inspect the MIL control circuit for a short to ground. If the circuit tests normal, replace the IPC.
4. Ignition ON, verify that the MIL illuminates with a 3A fused jumper between the MIL control circuit and ground.
*
ECM terminal X1-27 for RPO LE5 2.4L
*
ECM terminal X1-12 for RPO LAT-2.4L
‹› If the MIL does not illuminate test the MIL control circuit for a short to voltage or an open/high resistance. If the circuit tests normal replace
the ECM.
Repair Instructions