VUE FWD L4-2.4L (2008)
Transmission Position Switch/Sensor: Service and Repair
4T45-E - Automatic Transaxle
Park/Neutral Position Switch Replacement
Tools Required
J 41545 Park Neutral Position Switch Tool
Removal Procedure
1. Remove the automatic transmission range select lever. Refer to Automatic Transmission Range Selector Lever Replacement (See: Transmission
and Drivetrain/Automatic Transmission/Transaxle/Shift Linkage/Service and Repair) .
2. Disconnect the PNP switch electrical connector (3) from the PNP switch (4).
3. Remove the PNP switch bolt (2) and stud (1).
4. Remove the PNP switch (4) from the transaxle.
Installation Procedure (Old Switch)
1. Make sure the transaxle manual shaft is in the Neutral position.
2. Align the flats on the park/neutral position (PNP) switch with the transaxle manual shaft and install the PNP switch.
3. Loosely install the PNP switch bolt (2) and stud (1).
4. Connect the PNP switch electrical connector (3).
Important: After adjusting the switch, verify the engine only starts in Park or Neutral. If the engine starts in any other position, adjust
the switch.