VUE FWD L4-2.4L (2008)
5. Remove the battery positive cable junction block nut (1) and remove the battery positive cable from the junction block.
6. Remove the engine wiring harness ground bolt (1) and the battery negative cable ground at the back of the left side of the engine.
7. Remove the starter solenoid BAT terminal nut (2) and remove the battery positive cable from the starter solenoid BAT stud.
8. Remove the battery positive and negative cable from the vehicle.
9. Transfer the battery current sensor if replacing the battery positive and negative cable. Refer to Battery Current Sensor Replacement (See: Battery
Current Sensor/Service and Repair) .
Installation Procedure
Important: Route the battery positive and negative cable the same way as originally installed.
1. Install the battery positive and negative cable to the vehicle.