VUE FWD L4-2.4L Hybrid (2007)
8. On the driver side, disconnect the accessory wire harness.
9. Pull at the clip locations to disengage the side trim panel from the vehicle.
Installation Procedure
1. Position the rear side trim panel to the vehicle. Place the trim under the seat belt webbing.
2. On the driver side, connect the accessory wire harness.
3. Push at the clip locations to secure the panel to the vehicle.
4. Secure the weatherstrip seal over the trim edge.
5. Install the lock pillar garnish molding. Refer to Lock Pillar Upper Garnish Molding Replacement .