VUE FWD L4-2.4L Hybrid (2007)
Notice: To prevent bending of the sending unit float arm during removal, lift the pump module up slightly to disengage the orientation tabs in the
tank and rotate the module 45 degrees.
6. Remove the secondary fuel pump module.
Important: Always replace the fuel pump module-to-tank seal, O-ring, when the fuel pump module is removed.
7. Discard the fuel pump module-to-tank seal.
8. If the fuel level sending unit is being replaced as well, remove the secondary fuel level sender. Refer to Fuel Level Sensor Replacement (Primary)
Fuel Level Sensor Replacement (Secondary).
Installation Procedure
1. If the fuel level sending unit is being replaced, install the secondary fuel level sending unit into the new fuel pump. Refer to Fuel Level Sensor
Replacement (Primary) Fuel Level Sensor Replacement (Secondary).
2. Connect the suction port (1).
3. Insert the new secondary fuel pump module with the level sender and new fuel pump-to-tank seal. Ensure the orientation tabs are aligned.
4. Use the SA9156E to install the fuel pump lock ring.
5. Connect the EVAP line quick connect.
6. Install the fuel tank.