VUE FWD L4-2.4L Hybrid (2007)
Notice: Refer to Fastener Notice.
Important: Apply Permatex(R) 24200 on all restraint fasteners prior to installation.
1. Position the retractor into the rear seat back frame and install the fasteners.
Tighten the fasteners to 45 N.m (33 lb ft).
2. Position the retractor cover over the shoulder belt retractor and install the TORX(R) fasteners.
Tighten the fasteners to 20 N.m (15 lb ft).
Important: Verify that the shoulder belt is not twisted.
3. Route the webbing and the escutcheon through the seat back trim cover.
4. Continue to install the seat back trim cover by pressing over the hook and loop locations to ensure proper engagement.
5. Install the seat belt webbing bezel.
1. Slide the bezel inboard into the opening in the seat back.
2. Apply pressure along the outboard edge of the bezel to engage the locking tabs.
6. Route the recliner cable between the seat back and the panel.