VUE FWD L4-2.4L Hybrid (2007)
Apply sealer to a height and width of 2.5 mm (0.098 in).
Notice: The clutch cover housing must be fully seated to the rear drive module (RDM). Do Not use the mounting bolts to draw the cover to the
RDM. If the cover does not fully seat to the RDM, the clutch drum assembly splines must be realigned to the pinion shaft splines before
proceeding. Failure to follow these instructions will result in damage to the clutch assembly.
Important: Do not disturb the sealer bead applied to the RDM sealing surface.
7. Install the clutch housing cover (1) to the RDM.
Notice: Refer to Fastener Notice.
8. Hand install the clutch housing cover bolts (2).
Tighten the bolts to 26 N.m (19 lb ft).
9. Install the dust deflector (2) to the input flange (1) if removed.
