VUE FWD V6-3.5L (2008)
‹› If any of the resistance measurements for the On, Off, SET -, RES + and Cancel switches are not within the listed resistance values, replace the
steering wheel controls - left.
Repair Instructions
Perform the Diagnostic Repair Verification (See: Powertrain Management/Computers and Control Systems/Testing and Inspection/Diagnostic Trouble
Code Tests and Associated Procedures/Verification Tests and Procedures) after completing the diagnostic procedure.
*
Steering Wheel Control Switch Assembly Replacement (See: Accessories and Optional Equipment/Sensors and Switches - Accessories and
Optional Equipment/Steering Mounted Controls Assembly/Service and Repair)
*
Control Module References (See: Testing and Inspection/Programming and Relearning) for BCM replacement, setup, and programming
Cruise Control Switch Indicator Inoperative
Cruise Control Switch Indicator Inoperative
Diagnostic Instructions
*
Perform theDiagnostic System Check - Vehicle (See: Testing and Inspection/Initial Inspection and Diagnostic Overview/Diagnostic System
Check - Vehicle) prior to using this diagnostic procedure.
*
ReviewStrategy Based Diagnosis (See: Testing and Inspection/Initial Inspection and Diagnostic Overview/Strategy Based Diagnosis) for an
overview of the diagnostic approach.
*
Diagnostic Procedure Instructions (See: Testing and Inspection/Initial Inspection and Diagnostic Overview/Diagnostic Procedure Instructions)
provides an overview of each diagnostic category.
Circuit/System Description
The body control module (BCM) monitors the cruise control indicator switch. When the cruise on/off switch is switched ON, the cruise control switch is
closed and the cruise indicator signal circuit is high. When the cruise on/off switch is pressed OFF, the cruise control switch is open and the cruise
indicator signal circuit is low.
Reference Information
Schematic Reference
Cruise Control Schematics (See: Diagrams/Electrical Diagrams)
Connector End View Reference
Component Connector End Views (See: Diagrams/Connector Views)
Description and Operation
Cruise Control Description and Operation (See: Description and Operation)
Electrical Information Reference
*
Circuit Testing (See: Testing and Inspection/Component Tests and General Diagnostics)
*
Connector Repairs (See: Testing and Inspection/Component Tests and General Diagnostics)
*
Testing for Intermittent Conditions and Poor Connections (See: Testing and Inspection/Component Tests and General Diagnostics)
*
Wiring Repairs (See: Testing and Inspection/Component Tests and General Diagnostics)
Scan Tool Reference
Control Module References (See: Testing and Inspection/Programming and Relearning) for Scan Tool Information
Circuit/System Verification
Ignition ON, observe the cruise control indicator while applying the cruise On/Off switch. The indicator should turn on and off accordingly with the