VUE FWD V6-3.5L (2008)
Backup Lamp Switch: Service and Repair
Backup Lamp Switch Replacement
Removal Procedure
1. Raise and support the vehicle. Refer to Lifting and Jacking the Vehicle (See: Maintenance/Vehicle Lifting/Service and Repair) .
2. Disconnect the backup lamp switch electrical connector (1).
3. Remove the backup lamp switch from the transaxle.
Installation Procedure
Notice: Refer to Fastener Notice (See: Service Precautions/Vehicle Damage Warnings/Fastener Notice) .
1. Install the backup lamp switch.
Tighten the switch to 18 N.m (13 lb ft).