VUE FWD V6-3.5L (2008)
Knock Sensor: Service and Repair
Knock Sensor Replacement - Bank 1
Knock Sensor Replacement - Bank 1
Removal Procedure
1. Remove the right catalytic converter. Refer to Catalytic Converter Replacement - Right Side (LZ4-3.5L) (See: Emission Control
Systems/Catalytic Converter/Service and Repair/Catalytic Converter Replacement - Right Side) .
2. Remove the engine wiring harness heat shield nut (3).
3. Remove the engine wiring harness heat shield bolts (1 and 4).
4. Remove the engine wiring harness heat shield (2).
5. Disconnect the engine wiring harness electrical connector (5) from the knock sensor (2).