VUE FWD V6-3.5L (2008)
Power Distribution Relay: Service and Repair
Relay Replacement (Within an Electrical Center)
Relay Replacement (Within an Electrical Center)
Tools Required
J 43244 Relay Puller Pliers
Removal Procedure
1. Remove the electrical center cover.
2. Locate the relay. Refer to Electrical Center Identification Views (See: Fuse/Application and ID) to locate the electrical center where the relay
exists.
Important:
*
Always note the orientation of the relay.
*
Ensure that the electrical center is secure, as not to put added stress on the wires or terminals.
3. Using the J 43244 (1) position the tool on opposing corners of the relay (2).
Notice: Use J43244 to pull the relay straight out from the electrical center terminals. The use of pliers or a flat bladed tool could damage the
electrical center.
4. Remove the relay (2) from the electrical center.
Installation Procedure