VUE FWD V6-3.5L (2008)
Clutch Slave Cylinder: Service and Repair
Clutch Actuator Cylinder Replacement
Removal Procedure
1. Remove the clutch master cylinder hose retainer clip.
2. Disconnect the clutch master cylinder hose (1) from the transaxle.
3. Remove the transaxle. Refer to Transmission Replacement (See: Manual Transmission/Transaxle/Service and Repair/Transmission Replacement)
.
4. Remove the clutch actuator cylinder bolts from the transaxle.
5. Remove the clutch actuator cylinder.
Installation Procedure
Important: Excessive amounts of lubricant on the input shaft splines can contaminate the clutch disc and cause clutch shudder.
1. Lightly lubricate the inside diameter of the bearing with input shaft lubricant P/N 21005995 or equivalent.
2. Install the clutch actuator cylinder (1) to the transaxle.
Notice: Refer to Fastener Notice (See: Service Precautions/Vehicle Damage Warnings/Fastener Notice) .
3. Install the clutch actuator cylinder bolts.