tC L4-2.4L (2AZ-FE) (2005)
4.
Remove the sliding roof drive gear assembly
5.
Replace the sliding roof drive gear assembly with the NEW service part (P/N 63260-21051).
6.
Reinstall the 2 bolts nut and bracket to the drive gear.
7.
Reconnect the map light connector and install map light assembly.
8.
Connect the cable to the negative (-) battery terminal.
9.
Initialize the sliding roof gear. Refer to the Technical Information System (TIS):
^
2005/2006/2007/2008 model year Scion tC Repair Manual Vehicle Exterior - Sliding Roof/Convertible - "Sliding Roof System: Initialization".
A.
Turn the ignition switch ON.
B.
With the moon roof in the fully closed position press the close switch for approximately 2 seconds. When the sliding roof control ECU
initialization is finished the roof will automatically open and stop a few millimeters from the fully open position.
C.
Verify proper operation of "AUTO" mode.