tC L4-2.4L (2AZ-FE) (2005)
NOTICE: Prevent foreign matter from attaching to the sensor rotor.
b. Install a new skid control sensor to the rear axle hub & bearing assembly. The skid control sensor connector should be placed in the lowest
position.
HINT: The rear axle hub & bearing assembly should be placed with the narrow side facing the lower side.
c. Press the skid control sensor so that it becomes flat with the rear axle hub & bearing using the SST and a press.
SST 09214-76011
NOTICE:
-
Do not use a hammer on the skid control sensor.
-
Check that there is no foreign matter such as iron chips on the skid control sensor's detecting portion.
-
Slowly press the skid control sensor in straight.
8. INSTALL REAR AXLE HUB & BEARING ASSEMBLY LH
9. INSTALL REAR DISC
10. INSTALL REAR DISC BRAKE CALIPER ASSEMBLY LH
11. CONNECT SKID CONTROL SENSOR WIRE
12. INSTALL REAR WHEEL
Torque: 103 Nm (1,050 kgf-cm, 76 ft. lbs.)
13. INSPECT AND ADJUST REAR WHEEL ALIGNMENT
14. CHECK ABS SPEED SENSOR SIGNAL