tC L4-2.4L (2AZ-FE) (2005)
/Page-376002.png)
2. REMOVE WATER INLET
a. Remove the 2 nuts, then remove the water inlet from the cylinder block.
3. REMOVE THERMOSTAT
4. INSTALL THERMOSTAT
a. Install a new gasket onto the thermostat.
b. Install the thermostat with the jiggle valve upward.
HINT: The jiggle valve may be set to within 10° on either side of the prescribed position.
5. INSTALL WATER INLET
Torque: 9.0 Nm (92 kgf-cm, 80 inch lbs.)
6. ADD ENGINE COOLANT
7. CHECK FOR ENGINE COOLANT LEAKAGE
