tC L4-2.4L (2AZ-FE) (2005)
Marking position:
Height of Dimension A + Drill Bushing Height
5. Mark the tap and insert the driver.
A. Align the front tips of the core drill tap and insert driver.
B. Mark the tap and insert driver at the same height as the marking on the core drill.
NOTE
Work carefully so the markings do not rub off during the repair.
6. Provisionally install the drill fixture.
NOTICE
Move the pistons from the Top Dead Center position in order to avoid contact between pistons and drill fixture.
A. Install the drill bushing and alignment pin.