tC L4-2.4L (2AZ-FE) (2005)
G. Remove the shop cloth and protective tape.
NOTICE
Work carefully so the cutting particles do not fall on the engine.
H. Remove the drill fixture.
13. Repeat the insert installation process (steps 2 - 12) on the remaining bolt holes.
NOTE
The insert installation process MUST be performed on all 6 bolt holes regardless of the condition of the bolt hole. (See the Notice in
"Precautions for All Operations" in this TSB).
14. Reassemble the engine assembly.
Refer to the applicable model and model year Repair Manual section(s) on TIS.
15. Install the engine assembly into the vehicle.
Refer to the applicable model and model year Repair Manual section(s) on TIS.
16. Test drive to confirm the repair.