tC L4-2.4L (2AZ-FE) (2005)
/Page-314017.png)
E. Insert the nozzle all the way into the bolt hole and spray brake cleaner into the hole in order to flush out the cutting particles from inside it.
F. Return the cylinder block to a tilted position as shown in Figure 29.
G. Repeat steps 9B through 9F until the marking on the tap is aligned with the top surface of the bushing.
11. Check the bolt hole.
A. Invert the cylinder block so that it is upside-down.
B. Insert the nozzle all the way into the bolt hole and spray brake cleaner into the hole in order to flush out the cutting particles from inside it.
