tC L4-2.4L (2AZ-FE) (2005)
b. Using a wooden block and plastic faced hammer, tap a new gasket until it is flash with the exhaust pipe center.
NOTICE:
-
Make sure that the gasket is in the correct direction when installing.
-
Do not reuse a removed gasket.
-
Never push the gasket onto the exhaust pipe center by installing the exhaust pipe tail onto the exhaust pipe center.
c. Install the exhaust pipe tail to the 3 exhaust pipe supports.
d. Tighten the 2 compression springs and 2 bolts.
Torque: 43 Nm (440 kgf-cm, 32 ft. lbs.)
14. INSTALL HEATED OXYGEN SENSOR
SST 09224-00010
15. CONNECT BATTERY NEGATIVE TERMINAL
Torque: 5.4 Nm (55 kgf-cm, 48 inch lbs.)
16. CHECK FOR EXHAUST GAS LEAKAGE
17. INSTALL FLOOR PANEL BRACE FRONT
a. Install the floor panel brace front with the 4 bolts.
Torque: 29.6 Nm (300 kgf-cm, 22 ft. lbs.)
NOTICE: Make sure that the floor panel brace front is at the correct direction when installing.