tC L4-2.4L (2AZ-FE) (2005)
/Page-1239001.png)
Fuel Gauge: Testing and Inspection
INSPECT FUEL RECEIVER GAUGE
a. Inspect the circuit.
1. Disconnect the connector from the sender gauge.
2. Turn the ignition switch ON, then check the position of the receiver gauge needle.
OK: Needle position is on (EMPTY).
3. Connect terminals 2 and 3 on the wire harness side connector and turn the ignition switch ON, then check the position of the receiver gauge
needle.
OK: Needle position is on (FULL).
