tC L4-2.4L (2AZ-FE) (2005)
Fuel Pressure Pulsation Damper: Service and Repair
FUEL PRESSURE PULSATION DAMPER ASSEMBLY
REPLACEMENT
NOTE: When disconnecting the battery terminal, initialize the following system after the terminal is reconnected.
-
Power window control system
-
Sliding roof system
1. DISCHARGE FUEL SYSTEM PRESSURE
2. DISCONNECT BATTERY NEGATIVE TERMINAL
3. REMOVE ENGINE COVER SUB-ASSEMBLY NO.1
4. REMOVE AIR CLEANER CAP SUB-ASSEMBLY
5. REMOVE FUEL PRESSURE PULSATION DAMPER ASSEMBLY
a. Remove the fuel tube from the fuel hose clamp.
b. Remove the fuel pipe clamp No. 2.
c. Using SST, disconnect the fuel tube from the fuel delivery pipe.
SST 09268-21010
1. Hold the fuel tube connector in your hand, then install SST.
2. Turn SST to align the retainer inside the fuel tube connector with the chamfered part of SST. Insert SST into the fuel tube connector.
3. Hold SST in the position above, then push the fuel tube connector towards SST. Mount the retainer of the fuel tube connector onto the
chamfered part of SST.
HINT: The retainer of the fuel tube connector is unlocked.
4. Slide SST and fuel tube connector together to the fuel tube side until they make a "click" sound, then disconnect the fuel tube.