tC L4-2.4L (2AZ-FE) (2005)
Ignition Switch: Service and Repair
IGNITION OR STARTER SWITCH ASSEMBLY (2AZ-FE)
REPLACEMENT
NOTE: When disconnecting the battery terminal, initialize the following system after the terminal is reconnected.
-
Power window control system
-
Sliding roof system
1. DISCONNECT BATTERY NEGATIVE TERMINAL
2. REMOVE STEERING COLUMN COVER
3. REMOVE IGNITION OR STARTER SWITCH ASSEMBLY
a. Disconnect the ignition switch connector.
b. Disconnect the unlock warning switch connector.
c. Remove the band tie.
d. Using a small screwdriver, separate the claw fitting, then remove the connector of the unlock warning switch.
e. Remove the 2 screws, then remove the ignition switch.