tC L4-2.4L (2AZ-FE) (2005)
a. Perform a diagnostic system check (Refer to Diagnostic Strategies).
b. With the curtain shield airbag assembly installed on the vehicle, perform a visual check. If there are any defects as mentioned, replace the front
pillar garnish or roof headlining assembly with a new one: Cuts, minute cracks or marked discoloration on the front pillar garnish or roof
headlining assembly around the curtain shield airbag assembly.
8. CURTAIN SHIELD AIRBAG ASSEMBLY (VEHICLE INVOLVED IN COLLISION AND AIRBAG IS NOT DEPLOYED)
a. Perform a diagnostic system check (Refer to Diagnostic Strategies).
b. With the curtain shield airbag assembly removed from the vehicle, perform a visual check. If there are any defects as mentioned below, replace
the curtain shield airbag assembly with a new one:
-
Cuts, minute cracks or marked discoloration on the curtain shield airbag assembly.
-
Cracks or other damage to the connector.
CAUTION: For removal and installation procedures of the curtain shield airbag assembly, see "Replacement", and be sure to follow the
correct procedure.
9. INSTRUMENT PANEL AIRBAG ASSEMBLY LOWER NO.1 (VEHICLE NOT INVOLVED IN COLLISION)
a. Perform a diagnostic system check (Refer to Diagnostic Strategies).
b. With the instrument panel airbag assembly lower No.1 installed on the vehicle, perform a visual check. If there are any defects as mentioned
below, replace the instrument panel lower assembly with a new one:
Cuts, minute cracks or marked discoloration on the instrument panel lower assembly around the instrument panel air-bag assembly lower No.1.
10. INSTRUMENT PANEL AIRBAG ASSEMBLY LOWER NO.1 (VEHICLE INVOLVED IN COLLISION AND AIRBAG IS NOT DEPLOYED)