tC L4-2.4L (2AZ-FE) (2005)
Crankshaft Position Sensor: Service and Repair
CRANKSHAFT POSITION SENSOR
REPLACEMENT
NOTE: When disconnecting the battery terminal, initialize the following system after the terminal is reconnected.
-
Power window control system
-
Sliding roof system
1. DISCONNECT BATTERY NEGATIVE TERMINAL
2. REMOVE FRONT FENDER APRON SEAL RH
3. REMOVE FAN AND GENERATOR V BELT
SST 09249-63010
4. REMOVE GENERATOR ASSEMBLY
5. REMOVE CRANKSHAFT POSITION SENSOR
a. Disconnect the crankshaft position sensor connector.
b. Remove the connector clamp.
c. Remove wire harness from the wire harness clamp bracket.
d. Remove the wire harness clamp.
e. Remove the bolt, then crankshaft position sensor.
6. INSTALL CRANKSHAFT POSITION SENSOR
a. Apply a light coat of engine oil to the O-ring of the crankshaft position sensor.
b. Install the crankshaft position sensor with the bolt.