tC L4-2.4L (2AZ-FE) (2005)
Transmission Position Switch/Sensor: Service and Repair
PARK/NEUTRAL POSITION SWITCH ASSEMBLY (ATM)
REPLACEMENT
1. REMOVE ENGINE UNDER COVER LH
2. DISCONNECT TRANSMISSION CONTROL CABLE ASSEMBLY
a. Remove the nut from the control shaft lever.
b. Disconnect the control cable from the control shaft lever.
c. Remove the clip and disconnect the control cable from the control cable bracket.
3. REMOVE PARK/NEUTRAL POSITION SWITCH ASSEMBLY
a. Disconnect the park/neutral position switch connector.
b. Remove the nut, washer and control shaft lever.