tC L4-2.4L (2AZ-FE) (2005)
/Page-718007.png)
15. SEPARATE FRONT AXLE INBOARD JOINT BOOT LH CLAMP
a. One Touch Type: Using a screwdriver, separate the inboard joint boot LH clamp, as shown in the illustration.
b. Claw Engagement Type: Using needle-nose pliers, separate the inboard joint boot LH clamp, as shown in the illustration.
16. REMOVE FR AXLE INBOARD JOINT BOOT
a. Remove the inboard joint boot from the inboard joint assembly LH.
17. REMOVE FRONT DRIVE INBOARD JOINT ASSEMBLY LH
a. Remove the old grease from the inboard joint.
b. Put matchmarks on the inboard joint assembly LH and outboard joint shaft assembly LH.
NOTICE: Do not punch for the marks.
c. Remove the inboard joint assembly LH from the outboard joint shaft assembly LH.
d. Using a snap ring expander, remove the shaft snap ring.
