Transmission Position Switch/Sensor Testing (Page 3213)
c. Pry up the lock plate and remove the manual valve shaft nut and lock plate.
d. Remove the 2 bolts and pull out the park/neutral position switch.
4. INSTALL PARK/NEUTRAL POSITION SWITCH ASSEMBLY
a. Install the park/neutral position switch to the manual valve shaft.
b. Temporarily install the 2 bolts.
c. Place a new lock plate and tighten the nut.
Torque: 6.9 Nm (70 kgf-cm, 61 inch lbs.)
d. Temporarily install the control shaft lever.
e. Turn the lever counterclockwise until it stops, then turn it clockwise 2 notches.