tC L4-2.4L (2AZ-FE) (2005)
- Check that the vehicle body and windshield glass have a small gap between them.
3. Hold the windshield glass in place securely with protective tape or equivalent until the adhesive hardens.
12. INSTALL WINDSHIELD MOULDING OUTSIDE
a. Using a brush or sponge, apply Primer G to the contact surface of the windshield glass.
HINT: If primer G is applied to an area other than that which is specified, wipe off the primer with white gasoline before it dries.
NOTE:
-
Allow the Primer G to dry for 3 minutes or more.
-
Throw away any leftover Primer G.
-
Do not apply too much Primer G.
b. Install new windshield moulding outer upper before the adhesive dries.
NOTE: Do not drive the vehicle for the amount of time written in the table.
13. CHECK FOR LEAKS AND REPAIR
a. Conduct a leak test after the adhesive has completely hardened.
b. Seal any leaks with auto sealer.