xA L4-1.5L (1NZ-FE) (2006)
Wheel Speed Sensor: Service and Repair
Front Speed Sensor
REMOVAL
HINT:
-
Use the same procedures for the LH side and RH side.
-
The procedures listed below are for the LH side.
1. DISCONNECT CABLE FROM NEGATIVE BATTERY TERMINAL
CAUTION: Wait at least 90 seconds after disconnecting the cable from the negative (-) battery terminal to prevent airbag and seat belt
pretensioner activation.
2. REMOVE FRONT WHEEL
3. REMOVE FRONT SPEED SENSOR LH
a. Disconnect the speed sensor connector.
b. Remove the 2 clamp bolts holding the speed sensor wire harness from the body and shock absorber.
c. Disconnect the resin clip and speed sensor wire harness from shock absorber.
d. Remove the bolt and speed sensor.
NOTE: Keep the sensor tip and sensor installation hole free from foreign matter.
INSTALLATION
HINT:
-
Use the same procedures for the LH side and RH side.