xA L4-1.5L (1NZ-FE) (2006)
12. REMOVE RADIATOR ASSEMBLY
a) Disconnect the connector from the cooling fan motor and remove the radiator from the engine compartment.
b) Remove the 3 bolts and detach the fan shroud with fan.
c) Remove the 2 bolts and water filler.
d) Remove the 2 radiator support cushions and radiator support lower.
INSTALLATION
1. INSTALL RADIATOR ASSEMBLY
a) Install the 2 radiator support cushions and radiator support lower onto the radiator.
b) Install the water filler with the 2 bolts.
Torque: 7.5 Nm (76 kgf-cm, 66 inch lbs.)
c) Install the fan shroud with fan with the 3 bolts.
Torque: 7.5 Nm (76 kgf-cm, 66 inch lbs.)
d) Install the radiator, and connect the connector to the cooling fan motor.