xA L4-1.5L (1NZ-FE) (2006)
10. INSTALL CYLINDER HEAD COVER
a) Apply seal packing to the 2 locations shown in the illustration.
Seal packing: Part No. 08826-00080 or equivalent
NOTICE:
^
Remove any oil from the contact surface.
^
Install the cylinder head cover within 3 minutes of applying seal packing.
^
Do not start the engine for at least 2 hours after installation.
b) Install the cylinder head cover with the 9 bolts, 2 seal washers and 2 nuts.
c) Using several steps, uniformly tighten the bolts and nuts in the sequence shown in the illustration.
Torque: 10 Nm (102 kgf-cm, 7 ft. lbs.)
11. INSTALL IGNITION COIL
a) Install the 4 ignition coils with the 4 bolts.
Torque: 9.0 Nm (92 kgf-cm, 80 inch lbs.)
12. INSTALL NO. 2 CYLINDER HEAD COVER
a) First tighten the nuts labeled A, and then tighten nuts labeled B.
Torque: 7.0 Nm (71 kgf-cm, 62 inch lbs.)
13. INSPECT ENGINE OIL LEAKS
14. CONNECT CABLE TO NEGATIVE BATTERY TERMINAL
15. PERFORM INITIALIZATION
a) Perform initialization.