xA L4-1.5L (1NZ-FE) (2006)
b) Using a plastic-faced hammer and wooden block, tap in a new gasket until its surface is flush with the exhaust manifold.
NOTICE:
^
Tap in the gasket in the correct direction.
^
Do not reuse the removed gasket.
^
Do not to push in the gasket while installing the exhaust pipe.
c) Connect the 2 exhaust pipe supports, and install the exhaust pipe.
d) Install the 2 compression springs and 2 bolts.
Torque: 43 Nm (438 kgf-cm, 32 ft. lbs.)
e) Connect the 2 heated oxygen sensor connectors.
f) Install the grommet.