xA L4-1.5L (1NZ-FE) (2006)
3. After finishing the connection, check that the pipe and connector are securely connected by pulling them.
b. Install the fuel pipe clamp.
4. INSTALL CYLINDER HEAD COVER SUB-ASSEMBLY
5. INSTALL IGNITION COIL
6. CONNECT CABLE TO NEGATIVE BATTERY TERMINAL
7. CHECK FOR FUEL LEAKS
8. INSTALL NO. 2 CYLINDER HEAD COVER
a. Install the cylinder head cover.
b. First tighten the nuts labeled A, and then tighten the nuts labeled B.
Torque: 7.0 N.m (71 kgf.cm, 62 in.lbf)
9. PERFORM INITIALIZATION
a. Perform initialization.
NOTE: Certain systems need to be initialized after disconnecting and reconnecting the cable from the negative (-) battery terminal.