xA L4-1.5L (1NZ-FE) (2006)
/Page-752002.png)
c. Spark test flow chart.
1. Check that the wire harness side connector of the ignition coil is securely connected.
2. Perform spark test on each ignition coil.
1. Replace ignition coil with a normal one.
2. Perform spark test again.
3. Check power supply to ignition coil.
1. Disconnect the ignition coil connector.
2. Turn the ignition switch to ON.
3.
Using a voltmeter, measure the voltage between the terminals.
