xA L4-1.5L (1NZ-FE) (2006)
^
For details on how to use the GR8 Battery charger, please refer to the GR8 Instruction Manual located on TIS, Diagnostics - Battery.
Follow the procedures outlined in TSB No. SS002-07, "Techstream ECU Flash Reprogramming Procedure, " and flash the ECM/PCM with the
NEW calibration file update.
3.
Install the Authorized Modifications Label.
A.
Using a permanent marker, enter the following information on the label:
^
ECM/PCM part number: [Refer to the Parts Information section for the CURRENT PART NUMBER]
^
Calibration ID(s): [Refer to the Calibration Identification Chart for the NEW CALIBRATION ID]
^
Dealer Code
^
Repair Date
^
Change Authority (this TSB number): EG039-07
B.
Affix the Authorized Modifications Label to the vehicle at the locations shown in Figures 1 and 2. The Authorized Modifications Label is
available through the MDC, P/N 00451-00001-LBL.
4.
The repair is complete. Test drive the vehicle to confirm normal operation.
5.
Clear any DTCs that set during the reprogramming process.