xA L4-1.5L (1NZ-FE) (2006)
/Page-523001.png)
Camshaft Position Sensor: Service and Repair
REMOVAL
1. DISCONNECT CABLE FROM NEGATIVE BATTERY TERMINAL
CAUTION: Wait at least 90 seconds after disconnecting the cable from the negative (-) battery terminal to prevent airbag and seat belt
pretensioner activation.
2. REMOVE AIR CLEANER ASSEMBLY
3. DISCONNECT ENGINE WIRE
a. Disconnect the 2 clamps of the engine wire.
4. REMOVE CAMSHAFT POSITION SENSOR
a. Disconnect the sensor connector.
b. Remove the bolt and sensor.
INSTALLATION
1. INSTALL CAMSHAFT POSITION SENSOR