xA L4-1.5L (1NZ-FE) (2006)
Alternator: Service and Repair
Disassembly and Reassembly
DISASSEMBLY
1. REMOVE GENERATOR PULLEY
a. Hold SST (A) with a torque wrench, and tighten SST (B) clockwise to the specified torque.
SST 09820-63010 (09820-06010, 09820-06020)
Torque: 39 N.m (400 kgf.cm, 29 ft.lbf)
NOTE: Check that SST is secured to the rotor shaft.
b. Mount SST (C) in a vise.
c. Insert SST (B) into SST (C), and attach the pulley nut to SST (C).
d. To loosen the pulley nut, turn SST (A) in the direction shown in the illustration.
NOTE: To prevent damage to the rotor shaft, do not loosen the pulley nut more than one-half of a turn.
e. Remove the generator from SST (C).