xA L4-1.5L (1NZ-FE) (2006)
1. REMOVE CLUTCH START SWITCH ASSEMBLY
a. Disconnect the clutch start switch connector.
b. Remove the 2 nuts and clutch start switch with the bracket.
c. Remove the nut and clutch start switch from the bracket.
INSPECTION
1. INSPECT CLUTCH START SWITCH ASSEMBLY
a. Measure the resistance between the terminals when the switch is ON and OFF.
Standard resistance
Standard resistance
INSTALLATION
1. INSTALL CLUTCH START SWITCH ASSEMBLY
a. Install the clutch start switch to the bracket with the nut.
Torque: 6.2 Nm (63 kgf-cm, 55 inch lbs.)
b. Install the clutch start switch with the 2 nuts.
Torque: 6.2 Nm (63 kgf-cm, 55 inch lbs.)
c. Connect the clutch start switch connector.
2. INSPECT CLUTCH START SWITCH ASSEMBLY
a. Inspect the clutch start switch.