xA L4-1.5L (1NZ-FE) (2006)
/Page-1067003.png)
a. Apply grease to the needle roller bearing.
b. Install a new gasket to the control valve.
c. Align the matchmarks and install the control valve to the rack housing with the 2 bolts.
Torque: 21 Nm (214 kgf-cm, 15 ft. lbs.)
8. INSTALL RACK GUIDE
a. Install the rack guide, rack guide spring spacer and rack guide spring.
NOTICE: Make sure that the rack guide spring spacer is installed correctly
b. Apply sealant to 2 or 3 threads of the rack guide spring cap.
Sealant: Part No. 08833-00080, THREE BOND 1344, LOCTITE 242 or equivalent
c. Temporarily install the rack guide spring cap.
9. ADJUST TOTAL PRELOAD
a. To prevent the steering rack teeth from damaging the oil seal lip, temporarily install the RH and LH rack ends.
b. Using a 19 mm hexagon wrench, torque the rack guide spring cap.
Torque: 25 Nm (250 kgf-cm, 18 ft. lbs.)
c. Using a 19 mm hexagon wrench, return the rack guide spring cap approximately 12°.
