xA L4-1.5L (1NZ-FE) (2006)
/Page-1072001.png)
Ball Joint: Testing and Inspection
Manual Transaxle
INSPECTION
1. INSPECT FRONT SUSPENSION NO. 1 LOWER ARM SUB-ASSEMBLY LH
a. As shown in the illustration, flip the ball joint stud back and forth 5 times before installing the nut.
b. Using a torque wrench, turn the nut continuously at a rate of 2 to 4 seconds per turn and take the torque reading on the fifth turn.
HINT: A bolt without a torque specification is shown in the standard bolt chart.
