xA L4-1.5L (1NZ-FE) (2006)
b. Remove the bolt, and disconnect the sensor wire from the axle beam.
HINT: Disconnect the RH side using the same procedures as the LH side.
3. DISCONNECT REAR NO. 4 BRAKE TUBE
a. Using SST, disconnect the brake tube.
SST 09023-00101
b. Remove the clip.
NOTICE: The clip should not be reused.
4. DISCONNECT REAR NO. 3 BRAKE TUBE
HINT: Use the same procedures described for the No. 4 side.
5. DISCONNECT NO. 3 PARKING BRAKE CABLE ASSEMBLY
a. Remove the nut, and disconnect the parking brake cable from the axle beam.
6. DISCONNECT NO. 2 PARKING BRAKE CABLE ASSEMBLY
HINT: Use the same procedures described for the No. 3 side.
7. LOOSEN REAR AXLE BEAM ASSEMBLY
a. Loosen the 2 bolts.
NOTICE: Do not remove the bolt.