xA L4-1.5L (1NZ-FE) (2006)
HINT: Use the same procedures described for the LH side.
4. CONNECT NO. 3 PARKING BRAKE CABLE ASSEMBLY
a. Install the parking brake cable with the nut.
Torque: 5.4 Nm (55 kgf-cm, 48 inch lbs.)
5. CONNECT NO. 2 PARKING BRAKE CABLE ASSEMBLY
HINT: Use the same procedures described for the No. 3 cable.
6. CONNECT REAR NO. 4 BRAKE TUBE
a. Using SST, connect the brake tube to the flexible hose.
SST 09023-00101
Torque: 15 Nm (155 kgf-cm, 11 ft. lbs.)
b. Install the clip.
7. CONNECT REAR NO. 3 BRAKE TUBE
HINT: Use the same procedures described for the No. 4 tube.
8. CONNECT SKID CONTROL SENSOR WIRE
a. Install the sensor wire with the bolt.
Torque: 8.0 Nm (82 kgf-cm, 71 inch lbs.)
b. Connect the sensor connector.
HINT: Use the same procedures described for the other side.