xA L4-1.5L (1NZ-FE) (2006)
Wheel Bearing: Testing and Inspection
Rear Axle Hub
REAR AXLE HUB
ON-VEHICLE INSPECTION
1. CHECK REAR AXLE BEARING
a. Remove the rear wheel.
b. Remove the rear brake drum sub-assembly.
c. Inspect the bearing backlash.
1. Using a dial indicator, check for backlash near the center of the axle hub.
Maximum backlash: 0.05 mm (0.0020 inch)
If the backlash exceeds the maximum, replace the rear axle hub and bearing assembly.
d. Inspect the axle hub deviation.
1. Using a dial indicator, check for deviation in the surface of the axle hub inside the hub bolt.
Maximum deviation: 0.07 mm (0.0028 inch)
If the deviation exceeds the maximum, replace the rear axle hub and bearing assembly.