xA L4-1.5L (1NZ-FE) (2006)
/Page-834004.png)
a. Remove the bolt and transmission wire.
INSPECTION
1. INSPECT TRANSMISSION WIRE (ATF TEMPERATURE SENSOR)
a. Disconnect the E1 wire connector.
b. Measure the resistance of the transmission wire.
Standard resistance
Standard resistance
HINT: If the resistance is not as specified for either of the ATF temperatures shown in the table, the driveability of the vehicle may decrease.
Standard resistance
Standard resistance
INSTALLATION
1. INSTALL TRANSMISSION WIRE
a. Coat an O-ring with ATF.
b. Install the transmission wire.
